Casio PA-2400W Especificaciones descargar pdf (Pagina 39)

12. Display Drivers

Display drivers available from CASIO can consist of two different orientations, either Landscape or Portrait,

versions of 90-degree, 180-degree and 270-degree. These display drivers are used to re-position the LCD screen

of the PA-2400W at a tilted angle for such use as that for example the IrDA port to be located at the opposite

direction (to right side). The drivers are provided in the development kit and can be found as following names.

Table 12.1

File name of drivers Orientation in degree

DDI_90.DLL 90

DDI_180.DLL 180

DDI_270.DLL 270

12.1 Installation of the Display Drivers

Follow the installation steps bellow when you install one of the display drivers into the PA-2400W.

Installation

1. Rename the desired DDI_*.DLL file to DDI.DLL.

2. Download the "DDI.DLL" file to Windows directory in the PA-2400W by using communication software of

“Windows CE Services” or download it from a PC card.

3. When the installation is complete, press the RESET switch at the back of PA-2400W and start up it again.

4. As soon as the power is turned on and the display is resumed on the LCD display, be sure to perform the

calibration on the LCD touch panel.

The calibration mode can be started up by pressing down the <SIP> and <Backlight> buttons at the same

time. Once you are in the mode, tap “+” marking on each corner on the LCD touch panel with the stylus.

If you install this display driver once, it will stay active in the memory of the PA-2400W until a FULL

RESET will have been performed.

Restrictions

PA-2400W cannot display the software keyboard because the width of the keyboard is physically wider

than the height of the LCD screen of the PA-2400W when the LCD screen is tilted at 90 degrees (when

the 90-degree or 270-degree version is installed).

When you set the task bar to appear always on the LCD screen (when the 90-degree or 270-degree version

is installed), a warning message will appear.

Operations with the PIM software cannot be possible because it is for the Landscape-orientation display. If

you install the 90-degree or 270-degree version, your application software must be also changed for the

Portrait-orientation display.

1 2 ... 34 35 36 37 38 39 40

Sin comentarios

Casio PA-2400W Especificaciones Pagina 39