Casio E-Con EA-200 Guía de usuario descargar pdf (Pagina 62)

20031201

u To draw a graph using [Current] tab settings

• In either of the following cases, perform the same steps as those under “To draw a graph

using [Compare] tab settings” on page 8-8.

•When sampling is performed with [CASIO] - [Speaker (Sample Data)] specified as the

sensor

•When sampling is performed with [CASIO] - [Microphone] specified as the sensor, with

the [FFT Graph] setting turned on.

•When sampling is performed with [Vernier] - [Microphone] specified as the sensor, with

the [FFT Graph] setting turned on.

Note, however, that steps (3) through (8) of the above procedure can be skipped when

graphing current data.

• In cases other than those described above, perform the same steps as those under “To

draw a graph using [Normal] tab settings” on page 8-5.

Note, however, that steps (3) through (13) of the procedure can be skipped when graphing

current data.

u To clear all E-Con Graph Editor window settings

Note

• The following procedure clears all of the parameters (data assignments and graph settings)

on all three of the tabs of the E-Con Graph Editor window.

(1) Displays the E-Con Graph Editor window.

(2) On the menu bar, tap [Tool] and then [Clear All].

(3) In response to the confirmation message that appears, tap [OK] to clear all the data, or

[Cancel] to cancel.

8-10

Graphing Data

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 80 81

Sin comentarios

Casio E-Con EA-200 Guía de usuario Pagina 62