Casio MEP-U10 Guía de usuario descargar pdf (Pagina 16)

2. Check the condition of the tape.

• Make sure the tip of the tape is not bent. If it is, use scissors to cut off the bent part.

Tape

Pull out approximately 11 cm (4.3 in), measured

from the center of the roll to the tip of the tape.

3. Place the tape into the printer.

Run the tape over the rubber roller (see ﬁ gure below). Make sure the tape is seated

securely onto the bearing.

• When loading tape, take care not to touch the cutter. Touching the cutter can cause

ﬁ nger cuts.

• The printer head becomes hot during printing. Do not touch the printer head when

loading tape.

Important!

• Never try to push tape back in.

• Do not pull on the tape with excessive force. Doing so will lead to malfunction of

the printer.

• Note that normal printing may not be possible at the leading edge of a new roll of

tape.

• Incorrectly loading the tape can cause malfunction of the printer.

Cutter

Printer head

Bearing

Tape Rubber roller

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

Sin comentarios

Casio MEP-U10 Guía de usuario Pagina 16