
MIDI Data Format
A-30
J Reset All Controller
Format
n..........Voice Channel Number = 0H to FH (Ch1 to Ch16)
Recognition
Receipt of the Reset All Controller message causes the
following controllers to be reset.
Send
The Reset All Controller message is sent whenever you
change modes on the instrument (such as switching from
the Combination Mode to the mixer Mode).
J All Note Off
Format
n..........Voice Channel Number = 0H to FH (Ch1 to Ch16)
Recognition
Receipt of the All Note Off message mutes all tones being
played by data received over the MIDI channels (note off).
If Hold 1 or Sostenuto is turned on when the All Note Off
message is received, notes are sustained in accordance with
the corresponding pedal operation.
Send
This message cannot be sent.
J Omni Mode Off
Format
n..........Voice Channel Number = 0H to FH (Ch1 to Ch16)
Recognition
Receipt of an Omni Mode Off message does not turn off the
instrument Omni Mode. Receipt of an Omni Mode Off
message is treated as an All Note Off message.
Send
This message cannot be sent.
J Omni Mode On
Format
n..........Voice Channel Number = 0H to FH (Ch1 to Ch16)
Recognition
Receipt of an Omni Mode On message does not turn on the
instrument Omni Mode. Receipt of an Omni Mode On
message is treated as an All Note Off message.
Send
This message cannot be sent.
Byte 1 Byte 2 Byte 3
BnH 79H 00H
Controller Name Reset Value
Polyphonic Key Pressure vvH = 00H
Modulation Wheel vvH = 00H
Expression Controller vvH = 7FH
Hold 1 vvH = 00H
Portamento vvH = 00H
Sostenuto vvH = 00H
Soft vvH = 00H
NRPN msb = 7FH,
lsb = 7FH
RPN msb = 7FH,
lsb = 7FH
Channel Pressure vvH = 00H
Pitch Bend Change llH mmH = 00H 40H
Byte 1 Byte 2 Byte 3
BnH 7BH 00H
Byte 1 Byte 2 Byte 3
BnH 7CH 00H
Byte 1 Byte 2 Byte 3
BnH 7DH 00H
426-E-122A
PL40NE01-1.book 30 ページ 2002年7月23日 火曜日 午後6時52分
Comentarios a estos manuales