
22
Operating period Approx. 11 hours (with HA-D20BAT)*
Approx. 22 hours (with HA-D21LBAT)*
*; based on the ratio of cyclic
operation of
“Standby:Calculation:Scan” at
20:1:1 when the CPU speed is set
to auto power save mode and the
backlight is turned off.
Memory backup period RAM : Approx. 10 minutes,
Built-in clock : Approx. 72 hours
- Lithium battery pack is fully
charged.
- At room temperature.
Battery pack charge
period
Approx. 4 hours for HA-D20BAT
Approx. 7 hours for HA-D21LBAT
- The power on the IT-600
terminal is turned off.
- At room temperature
- The dedicated AC adaptor is
used to power the IT-600
terminal via battery charger or
cradle.
Memory backup battery
charge period
Approx. 4 days - Time period until when the
battery is fully charged.
- Battery pack is being installed.
- At room temperature.
Memory backup battery
rated capacity
10 mAh
Power supply by cradle Yes
By battery pack (when terminal’s
power on )
Ye s
Method to charge
memory backup battery
By battery pack (when terminal’s
power off)
Ye s
Dimensions and weight
Dimensions Approx. 166 (D) x 82 (W) x 27 (H) mm
Approx. 6.5 (D) x 3.2 (W) x 1.1 (H) inch.
Weight Approx. 290 g (or approx. 10.2 oz.) Including standard battery
pack installed.
• Terminal layout and the description for the SD Card slot
Table 2.2
Terminal no. Signal Description Direction
1 V BUS Power from USB cradle OUT/IN (see note)
2 V CRADLE Power supply/Charge to terminal -
3 D + USB D + IN/OUT
4 NC -
5 USB_ID Switch-over between USB host and USB client IN
6 D - USB D - IN/OUT
7 GND GND -
Note:
When the selector switch on the HA-D60IO is set to “USB Host”, this terminal outputs the power
ON/OFF control signal issued by the IT-600 to the cradle. Or, when it is set to “USB Client”, the
terminal is used to input the USB power (V BUS) from the cradle to the IT-600.
Comentarios a estos manuales