Casio DT-X30 R-50C Especificaciones descargar pdf (Pagina 190)

190

Read operation and Read operation 2 Tabs

These tabs are to set the following parameters related to scanning bar code symbologies. Choose a

mode you wish to set in each pull-down menu.

Options of read mode in Read operation Tab (see Figure 3.60)

• Selection of the read method, “Continuous read” or “Single read”.

• Selection of beam width for the scan width control function, “Wide”, “Middle” and “Narrow”.

• Selection of the scan verification beam function, “Disable” or “Enable”.

• Selection of the decoded data output destination, “OBR buffer”, “Clipboard”, or “Keyboard”.

• Selection of termination code, “Disable termination code”, “CR”, “LF”, “CR”, “LF”, or

“TAB”.

• Selection of the decoding level, “Normal” or “High”.

• Selection of the read mode, “Normal read” or “Gradation read (= Multi step read)”.

• Selection of the filter function, “With or without filter” or “With soft filter”. Note that other

filter modes in the pull-down menu are not operable with the terminal.

Options of mode in Read operation 2 Tab (see Figure 3.61)

• Selection of the gain, Gain Mode0 to Mode3.

• Selection of the learning decode function, “Learning Decode ON” or “Learning Decode OFF”.

Figure 3.60 Figure 3.61

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 332 333

Sin comentarios

Casio DT-X30 R-50C Especificaciones Pagina 190