Casio QV-10A Manual de usuario

Repair Guide for QV-10ContentsPAGERequirement ...Equipm

Memory error message appears on the display, whenQV-10 finds on error in the internal flash memory.Install the QV-10 service utility on your computer.

Remove the QV-10 service utility disk from drive A.Connecting QV-10 (DIGITAL terminal) to yourcomputer (D-Sub 9-pin).Use the cable and adaptor that co

Restoring images strored in QV-10 at memoryerror.If need a change of directory,PressPressto load the images on to hard disk and restores theimages on

The message on the camera's monitor will change"MEMORY EMPTY" to "MEMORY ERROR".If need a change of directory,PressPressto co

Set the aperture switch to F8 ( ) psotion and turn onthe camera.Pressto change the directory where the utility ADJ.EXEexists.Put on the color filter o

System block 1FECYSUM 3254E GRSUM 1EC33RKY A 6 RKC D RKG FEDDBKY 0 BKC FB BKG FEDDGKY 0 GKC FFD9 GKG 123ALPHAFFFC BETA A 8 TINT 9 8RAlimit -L 326 RAli

It is required whenever replacing the TFT-LCD.Output point: TP-410Adjust: VR-302 and VR3031. Ajust VR303 so that square-wave to read6.0 +/- 0.1V.2. Ad

Press the shutter button.Connect a cable to a photo diode and a photo sensor(IN).Connect a cable to an oscilloscope and the photosensor (OUT).Place th

Turn on the photo sensor Amp. and set RF RANGE inLOW.Adjust VR302 for ripple at minimum.-17-Procedure

Usage: FLASH (-s|-l) <filename> (-com*)(-b9600 | -b19200 | -b38400 | -b57600)-s : Saveflashmemorytothefile-l : Load th e filetoflashmemory-com*

PERSONAL COMPUTERIBM PC/AT or compatible RS-232C serial port ( D-Sub 9-pin )MS-WINDOWS Ver 3.1 or later Mouse or other pointing devices4MB of RAM (8MB

CASIO COMPUTER CO., LTD.OVERSEAS SERVICE DIVISION8-11-10, Nishi-ShinjukuShinjuku-ku, Tokyo 160, JapanTelephone: 03-3347-4926FAX: 03-3347-4973Printer i

SOLDERING IRON and SOLDERKOTELYZERANALOG VOLTMETERTWEEZERS and SCREW DRIVERCABLEEquipment and Tool-2-PHOTO SENSOR AMP.

Remove the two screws from the lower case.Remove the two screws from the lower case.Pull out the lower case.Take the battery cover.Pull out the keybor

No power onCheck the power switch.Check the fuse (FU500) by using multimeter.Take the fuse (FU-100) by using multimeter.Replace the backlight or the L

Remove the connector from the linear PCB.Loose the connector then the release hook. Pull outthe linear PCB.Remove the four screws from the upper case.

Defective the camera unit.Remove the two screws.Pull out the two connectors.Pull out the two flat cables from the connectors.Replace the camera unit.C

Poor soldering on the power jack.Remove the one screw from the lower case.The coonector(s) of the power jack should besoldered.Sudden power failure.-7

Assembly can be performed in the reverse order ofthe disassembly steps.There are three major points of assembly work.2. Gently set the switch knob to